Each AMERACAT is custom built with Hand Laid stitched fabrics, foam core construction and
The twin Catamaran Hulls are filled with closed cell foam for UNSINKABLE Flotation and the entire AMERACAT hull is built in the mold as one monolithic part with no glued or screwed deck joints to fail.
- Marine Grade UV Stabilized Gel Coat on the Exterior in your choice of colors.
- Marine Grade UV Stabilized Gel Coat on the Interior with Anti-Skid for sure footing.
- The Hull is constructed of Stitched Biaxial and Triaxial Fabric for bullet proof strength.
- 2mm Coremat Xi is used in the side of the hull to ensure a smooth finish free from print through.
- 3” PVC Rigging Tubes are Glassed into the Hull that run Bow to Stern.
- Each Hull is filled with Closed Cell Foam.
- 3/4” Airex High Density Foam Board is used for the Cockpit Sole (floor).(1 1/2" Airex for the 31' & 33')
- 2" Ultra High Density Foam encapsulated in Stitched Fabric makes up the transom.
- Polyurethane Foam is also encapsulated to form a structual Gunnel that can accept rod holders.
- Our Rolled edge design is stronger than a shoe box hull to deck joint used by other builders.
- Exclusive "Sponson Drainage Safeguard System"
3 " PVC rigging tubes are glassed to
the top edge of the tunnel for added
strength and used as a wire way.
3/4" Airex high density foam panels
are bonded to the top of the tunnel to
form the cockpit floor, then encapsulated
with Biaxial fiberglass fabric.
1 1/2" thick Airex used for the 31' & 33'
Each sponson is completely filled
with Closed Cell foam flotation.
AMERACAT
AFFORDABLE POWER CATAMARANS
No Boat of equal size can match our Smooth Dry Ride
NO WOOD
Sponson Drainage Safeguard System
Alum. Fuel Cell with internal structural baffles
Formed sides with overlapped radius, S.S. pick ups and Wema sender